GPL - Gate Question |

X Close

You need to enable javascript to view this page properly.

Branch

All

Loading

721.

Fourier Series for the waveform, f(t) shown in Fig. is

[1 mark]

asked in Electrical Engineering, 2002

View Comments [0 Reply]
722.

A current impulse, 5δ(t), is forced through a capacitor C. The voltage, V_c(t), across the capacitor is given by [1 mark]
(a) 5t
(b) 5u(t) - C
(c) 5t/C
(d) 5u(t)/C

asked in Electrical Engineering, 2002

View Comments [0 Reply]
723.

A separately excited dc motor is controlled by varying its armature voltage using a single phase full-converter bridge as shown in Fig. the field current is kept constant at the rated value. The motor has an armature resistance of 0.2Ω, and the motor voltage constant is 2.5 V/(rad/sec). The motor is driving a mechanical load having a constant torque of 140 Nm. The triggering angle of the converter is 60°. The armature current can be assumed to be continuous and ripple free.
(a) Calculate the motor armature current
(b) Evaluate the motor speed in rad/sec.
(c) Calculate the rms value of the fundamental component of the input current to the bridge.

[5 marks]

last reply by CpjJwWHV • 13 years ago • asked in Electrical Engineering, 2001

View Comments [2 Reply]
724.

A voltage commutated thyristor chopper circuit is shown in Fig. The chopper is operated at 500 Hz with 50% duty ratio. The load takes a constant current of 20A.
(a) Evaluate the circuit turn off time for the main thyristor Th_i.
(b) Calculate the value of inductor L, if the peak current through the main thyristor Th_i is limited to 180% of the load current.
(c) Calculate the maximum instantaneous output voltage of the chopper.

[5 marks]

asked in Electrical Engineering, 2001

View Comments [0 Reply]
725.

A simple active filter is shown in Fig. Assume ideal op-amp. Derive the transfer function v₀/v₁ of the circuit, and state the type of the filter (i.e., highpass, low-pass, band-pass, or band-reject). Determine the required values of R₁, R₂ and C in order for the filter to have a 3-dB frequency of 1 kHz, a highfrequency input resistance of 100 kΩ, and a high frequency gain magnitude of 10.

[5 marks]

asked in Electrical Engineering, 2001

View Comments [0 Reply]
726.

The transistor in the amplifier circuit shown in Fig. is biased at I_C = 1mA. Use V_T = KT/q = 26 mV, β_o = 200, r_b = 0 and r_o →∞
(a) Determine the ac small signal midband voltage gain v₀/v_I of the circuit.
(b) Determine the required value of C_E for the circuit to have a lower cutoff frequency of 10 Hz.

[5 marks]

last reply by CpjJwWHV • 13 years ago • asked in Electrical Engineering, 2001

View Comments [1 Reply]

792 1 ...‹‹119 120121 122 123 ›› ... 132

High Frequency Word List with Mnemonics

GPL Dictionary is fast way to learn words with mnemonics.
It contains high frequency word list which are mostly asked in various examinations.
It is dedicated for student appearing for PSUs, GRE, UPSC or any other exams in which vocabulary test is taken.
User can save their own mnemonics (key and link).

Check Now