GPL - IES Question |

X Close

You need to enable javascript to view this page properly.

Branch

All

Loading

139.

The lead time in material requirements planning is the time between
(a) floating the tender and receiving the quotations from the vendor
(b) floating the tender and placing the purchase order of the vendor
(c) floating the tender and receiving the material from the vendor
(d) issueing purchase order and receiving the material from the vendor

asked in Mechanical Paper-2, 2010

View Comments [0 Reply]
140.

Which of the following statements is not correct for the TQC?
(a) It is about the product quality and quality of all business processes
(b) It is restricted to product quality
(c) It utilizes quality circles
(d) It utilizes zero defect programmes

asked in Mechanical Paper-2, 2010

View Comments [0 Reply]
141.

The probability law that determines the fluctuations of fraction defective is
(a) Poisson
(b) Normal
(c) Binomial
(d) Exponential

asked in Mechanical Paper-2, 2010

View Comments [0 Reply]
142.

In assignment problem for variable x_ij
1. x_ij = 1 or 0

Which of these are correct?
(a) 1, 2 and 3
(b) 2 and 3
(c) 1 and 2
(d) 1 and 3

asked in Mechanical Paper-2, 2010

View Comments [0 Reply]
143.

In the Kendall's notation for representing queuing models, the first position represents
(a) probability law for the arrival
(b) probability law for the service
(c) number of channels
(d) capacity of the channels

asked in Mechanical Paper-2, 2010

View Comments [0 Reply]
144.

Consider the following statements:
1. For the application of optimality test in case of transportation model, the number of allocations should be equal to m + n, where m is the number of rows and n is the number of columns of matrix.
2. Transportation problem is a specific case of linear programming problem.
3. In case of assignment problem the first step is to make a square matrix by adding a dummy row or a dummy column.
Which of the above statements is/are correct?
(a) 1, 2 and 3
(b) 1 and 2
(c) 2 and 3
(d) 2 only

asked in Mechanical Paper-2, 2010

View Comments [0 Reply]

1430 1 ...‹‹22 2324 25 26 ›› ... 239